How to Change Water Filter in Whirlpool Refrigerator

Changing the water filter in your Whirlpool refrigerator ensures you have clean, fresh-tasting water and ice. Regular replacement not only maintains optimal water quality but also prolongs the lifespan of your refrigerator. This guide explains the step-by-step process to help you replace the water filter efficiently.

Identifying Your Refrigerator Model

Before starting, it’s essential to identify your Whirlpool refrigerator model, as water filters may vary. Typically, you'll find the model number on the inner wall inside the fridge or on the interior liner of the door. Once identified, refer to the user manual to determine the compatible water filter type.

Tools and Supplies Needed

Ensure you have the right tools and replacement filter on hand before beginning.

Step-by-Step Instructions

1. Locate the Water Filter

Most Whirlpool refrigerators have the water filter located either in the upper right corner inside the refrigerator compartment or in the grille at the bottom front.

Upper Right Corner

1. Open the refrigerator door.
2. Look for the filter cover in the upper right corner.

Bottom Grille

1. Locate the grille at the base of the fridge.
2. If the grille is removable, disengage the clips and pull it out gently.

2. Remove the Old Filter

1. Turn Off Water Supply: It's a good practice to turn off the water supply to prevent spills. The valve is usually located behind the refrigerator.

2. Release the Filter: Depending on the location:

   • Upper Right Corner: Push the eject button to release the filter. Alternatively, turn the filter counterclockwise to unlock.
   • Bottom Grille: Twist the filter counterclockwise until it releases.

3. Inspect the Old Filter: Note any buildup or discolouration.

3. Install the New Filter

1. Prepare the New Filter: Unpack and remove any protective caps from the new filter.

2. Insert the New Filter:

   • Upper Right Corner: Align the new filter with the compartment and push it in until it clicks. If applicable, turn it clockwise to lock.
   • Bottom Grille: Insert the new filter and turn it clockwise until secure.

4. Restore Water Supply and Reset Indicator

1. Turn On Water Supply: Reconnect the water supply and check for leaks.

2. Reset the Filter Indicator: Reset the filter status light by pressing and holding the reset button (refer to the user manual for specific instructions for your model).

5. Run Water through the New Filter

Once installed, run about two to four gallons of water through the water dispenser to clear any air and remove potential debris. This step ensures your new filter is fully functional.

Troubleshooting Tips

• Water Flow Issues: If experiencing slow water flow after installation, ensure the filter is correctly locked and the water supply is fully open.

• Continuous Indicator Light: Verify the reset process and ensure it was correctly performed. Check your user manual for model-specific indicator instructions.

Regularly changing your water filter every six months, or as needed, will maintain the quality of your drinking water and keep your Whirlpool refrigerator running optimally.