Jenn Air Refrigerator Owner's Manual

Installation

Selecting the Best Location

Selecting the optimal location for your Jenn Air refrigerator ensures efficient operation and longevity. Consider the following guidelines:

1. Proximity to Power Supply: Ensure the location is near a grounded electrical outlet. Avoid using extension cords.
2. Ventilation: Allow at least 2 inches of space on the top and sides of the refrigerator to ensure adequate air circulation.
3. Temperature Considerations: Avoid installing the refrigerator in areas prone to extreme temperatures or direct sunlight, as this can affect efficiency.
4. Floor Surface: Choose a level, sturdy floor to support the weight of the refrigerator and to prevent vibration and noise.

Tools Required for Installation

To successfully install your Jenn Air refrigerator, you’ll need the following tools:

• Phillips head screwdriver
• Adjustable wrench
• Level
• Tape measure
• Bucket (for water supply connection)

Step-by-Step Installation Process

Follow these steps to properly install your refrigerator:

1. Unpack the Refrigerator: Carefully remove packaging. Inspect for any damage that might have occurred during shipping.
2. Position the Appliance: Move the refrigerator to the predetermined location, ensuring there’s enough space for ventilation.
3. Adjust Leveling Legs: Make sure the refrigerator is balanced. Use a level and adjust the leveling legs to achieve a stable position.
4. Connect the Water Supply (if applicable): Follow the section on connecting the water supply for instructions.
5. Plug in the Refrigerator: Connect the unit to the electrical outlet, ensuring the plug fits securely.

Levelling Your Refrigerator

Proper leveling is crucial to avoid noise and promote efficient operation.

1. Use a Level: Place a level on top of the refrigerator.
2. Adjust Legs: Rotate the leveling legs, either clockwise to raise or counterclockwise to lower, until the refrigerator is level both front-to-back and side-to-side.
3. Recheck the Alignment: Once adjusted, double-check with the level to confirm stability.

Connecting Water Supply

For models with a water dispenser or ice maker, connect the water supply as follows:

1. Locate the Water Valve: Typically situated behind or below the refrigerator.
2. Insert Tubing: Attach the water line tubing to the valve, ensuring the connection is secure to prevent leaks.
3. Turn On Water Supply: Slowly turn on the water valve and check for leaks.

Initial Power Setup and Testing

After installation, verify the refrigerator’s functionality:

1. Temperature Test: Allow 24 hours for the refrigerator to reach optimal temperature.
2. Ice Maker Test: If applicable, allow up to 24 hours to produce ice cubes, then check for appropriate ice production.
3. Water Dispenser Test: Run the water dispenser to confirm correct water flow and air removal from the system.

Setting the Temperature Controls

Configure the internal temperature to preserve food quality:

1. Locate Controls: Find the digital or manual controls typically inside the refrigerator.
2. Set Temperatures: Recommended settings are 37°F (3°C) for the refrigerator and 0°F (-18°C) for the freezer. Adjust as needed based on load and climate conditions.
3. Monitor Performance: Check temperatures periodically, especially after the initial setup.

Important Safety Precautions

Ensure safe operation and avoid hazards by following these precautions:

• Electrical Safety: Ensure the plug fits securely in the outlet and avoid using damaged cords.
• Avoid Overloading: Do not exceed recommended shelf weight limits to prevent collapse.
• Fire Safety: Do not store flammable substances in or around the refrigerator.
• Child Safety: Use child-proof locks if necessary to prevent accidents.
• Disconnect Before Maintenance: Always unplug the refrigerator before performing maintenance or repairs.