Pelco Refrigerator Owner's Manual

Installation

Unpacking the Refrigerator

Upon receiving your new Pelco refrigerator, it is important to carefully unpack it to avoid any damage. Begin by inspecting the packaging for any visible damage during transit. Use a utility knife or scissors to remove the outer packaging, taking care not to scratch the refrigerator's surface. Once the outer packaging is removed, open the refrigerator doors and remove any interior packaging materials, such as foam blocks and plastic coverings, ensuring the components within are undamaged.

Choosing the Correct Location

Selecting the right location for your refrigerator is crucial for optimal performance and efficiency. Ensure the location meets the following criteria:

• Even Surface: Place the refrigerator on a flat, stable surface to ensure stability and prevent unnecessary vibrations or noise.
• Room Temperature: The ambient temperature should be between 50°F to 85°F (10°C to 29°C) for best performance.
• Clearance: Leave at least 2 inches of space on both sides and the back for adequate ventilation, and ensure there is sufficient room to open the refrigerator doors fully without obstruction.
• Away from Heat Sources: Avoid placing the refrigerator near heat sources such as ovens, radiators, or direct sunlight, as these can hinder its cooling efficiency.

Leveling the Unit

Proper leveling of the refrigerator is essential to ensure door alignment and optimal performance. To level the unit, follow these steps:

1. Locate the Adjustable Legs: Identify the adjustable leveling legs located at the front corners of the unit.
2. Adjust with a Wrench: Use a wrench to turn the leveling legs. Clockwise rotations will raise the refrigerator, while counterclockwise turns will lower it.
3. Use a Level Tool: Place a spirit level on top of the refrigerator to check its alignment.
4. Fine-tune as Necessary: Continue adjusting the legs until the unit is level in both front-to-back and side-to-side orientations.

Connecting to Power

Once the unit is properly leveled, it's time to connect it to a power source:

1. Verify Outlet Voltage: Ensure the electrical outlet matches the refrigerator’s voltage requirements, as specified in the user manual.
2. Avoid Extensions: Plug the refrigerator directly into the outlet without using extension cords to prevent potential electrical hazards.
3. Power On: Turn the refrigerator on using the power button or dial within the unit.

Water Line Connection (if applicable)

For models equipped with a water and ice dispenser, connecting the water line is essential. Follow these steps to complete the connection:

1. Locate the Water Line: Identify the water line connector at the rear of the refrigerator.
2. Shut Off Water Supply: Turn off the main water supply before connecting the line.
3. Attach the Water Line: Use the provided fittings to securely attach the water line to the connector.
4. Check for Leaks: Gradually turn the water supply back on and inspect for any leaks, tightening connections if necessary.

Initial Temperature Setup

For optimal food preservation, it is important to configure the initial temperature settings:

1. Access Temperature Controls: Locate the control panel inside the refrigerator or at its front display.
2. Set Refrigerator Temperature: Adjust the refrigerator compartment to a recommended 37°F (3°C).
3. Set Freezer Temperature: Set the freezer compartment to a recommended 0°F (-18°C).
4. Allow for Stabilization: Allow the unit to reach these temperatures, which may take several hours.

Installation Checklist

Before using your refrigerator, ensure the following tasks have been completed:

• [ ] Refrigerator has been unpacked and inspected for damages.
• [ ] Location is suitable, with adequate clearance and away from heat sources.
• [ ] Unit is level and stable.
• [ ] Connected to a functioning power source without extensions.
• [ ] Water line is properly connected (if applicable).
• [ ] Initial temperature settings are configured correctly.
• [ ] All packaging materials removed from the interior compartments.

With these steps completed, your Pelco refrigerator is ready for use! Enjoy your new appliance and the benefits it brings to your home.