Professional Series Refrigerator Owner's Manual

Installation

Unpacking Your Refrigerator

When you receive your new Professional Series Refrigerator, it’s important to unpack it carefully to avoid any damage. Begin by positioning the packaging upright in the intended installation location. Use scissors or a box cutter to carefully cut the packing tape, taking care not to scratch the surface of the appliance. Remove the top of the box first, then proceed to remove the side panels. Lift the refrigerator carefully and remove any additional protective plastic covering or tapes from the appliance. Be sure to keep the user manual and any included documentation for reference.

Choosing the Right Location

Selecting the appropriate spot for your refrigerator is crucial for optimal performance. Ensure the location is level, well-ventilated, and away from direct sunlight, heat sources such as ovens, and moisture. There should be at least a two-inch clearance on all sides to accommodate airflow and door swing. Additionally, confirm that the chosen location is close to a grounded electrical outlet and a water supply line if your refrigerator has a water dispenser.

Electrical Requirements

Your Professional Series Refrigerator requires a dedicated, grounded electrical circuit to operate efficiently. Ensure your outlet provides a standard voltage of 120/60Hz. Use only copper wire for your circuit, as aluminum can cause overheating. Avoid using extension cords, as these can compromise performance and safety. If you must use an extended power option, a surge protector is essential to safeguard your appliance.

Proper Ventilation Guidelines

Adequate ventilation is essential for maintaining your refrigerator’s efficiency and longevity. Your appliance needs room to breathe. Ensure a minimum of two inches of clearance around the sides, back, and top. This spacing promotes air circulation and prevents overheating, thereby ensuring consistent cooling and efficiency.

Leveling the Appliance

An unlevel refrigerator can lead to inefficient operation and potential door-sealing issues. Use the adjustable feet located at the bottom of your refrigerator to achieve balance. With a carpenter’s level, ensure the appliance is perfectly horizontal from all sides. Adjust the feet by turning them clockwise to raise or counterclockwise to lower until balanced.

Connecting the Water Supply

If your model features an ice maker or water dispenser, connecting to a water supply is essential. Locate the closest cold water pipe, ensuring it’s within reach. Use a 1/4 inch copper or stainless steel braided tubing to connect from your water supply to the refrigerator’s inlet valve. Secure all connections with a wrench, avoiding overtightening that could damage threads. Finally, turn on the water supply and check for leaks before usage.

Final Installation Checklist

Before considering your installation complete, refer to this checklist:

• [ ] Refrigerator is unpacked and protective coatings removed.
• [ ] Correct location selected and surface is level.
• [ ] Proper clearance is ensured for ventilation.
• [ ] Refrigerator is level and stabilized.
• [ ] Water supply, if applicable, is connected and leak-tested.
• [ ] Electrical outlet is the correct specification and appliance is plugged securely.

Adequately following these steps and checklist ensures your Professional Series Refrigerator is well-prepared for optimal function and longevity.